China Used Phase Noise Analyzer Rohde Schwarz FSWP26 Manufacturers Factory Suppliers
-
Used Phase Noise Analyzer Rohde & Schwarz FSWP26
For high-end applications, the Rohde & Schwarz FSWP26 can be equipped with a second receive path, which enables cross-correlation and, depending on the number of correlations used, increases...
-
Used Signal Source Analyzer Rohde & Schwarz FSUP26
Use the FSUP26 to measure phase noise and when characterizing oscillators, measure tuning slope, transient response, power, harmonics and spurious emissions, as well as amplifier noise.
-
Used Noise Figure Meter Agilent N8974A
The Agilent N8974A offers simultaneous noise figure and gain measurements with the ability to view, print and save the data/display in multiple formats.
-
Used Noise Figure Analyzer Agilent N8973B
Default noise figure settings offer simultaneous noise figure and gain measurements. By using Table view several measurements including Noise Figure, Noise Factor, Y-Factor, Gain, Phot, Pcold, and...
-
Used Noise Source Agilent N4002A
The Keysight N4002A (Agilent) Noise Source is perfect for general purpose use with a low reflection coefficent and a nominal ENR of 15 dB from 10 MHz to 26.5 GHz. DUT's with noise figures up to 30...
-
Used Noise Source Agilent N4000A
DUT's with noise figure up to 20 dB can be accurately and reliably measured with this device. The N4000A noise sources has a choice of connectors, with an APC 3.5(mm) connector as standard.
-
Used Phase Noise Analyzer Agilent E5503B
By building upon 30 years of Agilent Technologies low phase noise, RF design and measurement experience, the Agilent E5503B solution continues to provide excellent measurement integrity,...
-
Used Microwave Downconverter Agilent E5053A
When configured with the Agilent E5053A microwave downconverter, the E5052A and E5052B SSA offers exceptional phase noise sensitivity up to 26.5 GHz.
-
Used Signal Source Analyzer Agilent E5052B
The E5052B SSA is suitable for use in a wide range of applications including RF/uW/mmW oscillators, VCO's, system reference clocks, LAN modules, high-speed timing modules, SerDes chips, and...
-
Used Noise Figure Test Agilent 8971C
When paired with the measurement modes in an 8970B, double down-conversion is possible because the 8971C acts as the second downconverter.
-
Used Noise Source Agilent 346B
The low SWR of the Keysight 346B noise source reduces a major source of measurement uncertainty; reflections of test signals. The 346B's high ENR, low SWR, and variety of connectors make it a...
-
Used Noise Source Agilent 346A
The very small change in reflection coefficient (<0.01) from ON to OFF is designed especially for accurate characterization of input-impedance-sensitive devices (like GaAsFETs and many UHF...


