China Used Phase Noise Analyzer Rohde Schwarz FSWP8 Manufacturers Factory Suppliers
-
Used Phase Noise Analyzer Rohde & Schwarz FSWP8
The FSWP8 Phase Noise Analyzer does not require external reference sources. Its internal local oscillator surpasses almost any generator available on the market when it comes to phase noise...
-
Used Phase Noise Analyzer Rohde & Schwarz FSWP50
For high-end applications, the Rohde & Schwarz FSWP50 can be equipped with a second receive path, which enables cross-correlation and, depending on the number of correlations used, increases...
-
Used Signal Source Analyzer Rohde & Schwarz FSUP26
Use the FSUP26 to measure phase noise and when characterizing oscillators, measure tuning slope, transient response, power, harmonics and spurious emissions, as well as amplifier noise.
-
Used Noise Figure Meter Agilent N8974A
The Agilent N8974A offers simultaneous noise figure and gain measurements with the ability to view, print and save the data/display in multiple formats.
-
Used Noise Source Agilent N4002A
The Keysight N4002A (Agilent) Noise Source is perfect for general purpose use with a low reflection coefficent and a nominal ENR of 15 dB from 10 MHz to 26.5 GHz. DUT's with noise figures up to 30...
-
Used Noise Source Agilent N4001A
●Frequency Range: 10 MHz - 18 GHz
●Nominal ENR 15dB
●Electronic storage of Excess Noise Ratio (ENR) calibration data decreases the opportunity for user error -
Used Signal Source Analyzer Agilent E5052B
The E5052B SSA is suitable for use in a wide range of applications including RF/uW/mmW oscillators, VCO's, system reference clocks, LAN modules, high-speed timing modules, SerDes chips, and...
-
Used Signal Source Analyzer Agilent E5052A
The Keysight E5052A has a frequency range that can be extended up to 26.5 GHz with the Agilent E5053A, and up to 110 GHz with the E5053A plus Keysight 11970 (Agilent) series mixers.
-
Used Noise Figure Test Agilent 8971C
When paired with the measurement modes in an 8970B, double down-conversion is possible because the 8971C acts as the second downconverter.
-
Used Noise Figure Meter Agilent 8970B
RF and microwave (with external local oscillator, sold separately) measurements from 10MHz to at least 26.5GHz are equally simple; any IF between 10 and 1500 MHz may be used.
-
Used Noise Source Agilent 346B
The low SWR of the Keysight 346B noise source reduces a major source of measurement uncertainty; reflections of test signals. The 346B's high ENR, low SWR, and variety of connectors make it a...
-
Used Noise Source Agilent 346A
The very small change in reflection coefficient (<0.01) from ON to OFF is designed especially for accurate characterization of input-impedance-sensitive devices (like GaAsFETs and many UHF...


