China Used Noise Figure Meter Agilent 8970B Manufacturers Factory Suppliers
-
Used Noise Figure Meter Agilent 8970B
RF and microwave (with external local oscillator, sold separately) measurements from 10MHz to at least 26.5GHz are equally simple; any IF between 10 and 1500 MHz may be used.
-
Used Phase Noise Analyzer Rohde & Schwarz FSWP50
For high-end applications, the Rohde & Schwarz FSWP50 can be equipped with a second receive path, which enables cross-correlation and, depending on the number of correlations used, increases...
-
Used Signal Source Analyzer Rohde & Schwarz FSUP26
Use the FSUP26 to measure phase noise and when characterizing oscillators, measure tuning slope, transient response, power, harmonics and spurious emissions, as well as amplifier noise.
-
Used Noise Figure Meter Agilent N8974A
The Agilent N8974A offers simultaneous noise figure and gain measurements with the ability to view, print and save the data/display in multiple formats.
-
Used Noise Figure Analyzer Agilent N8973A
The Keysight N8973A offers simultaneous noise figure and gain measurements with the ability to view, print and save the data / display in multiple formats.
-
Used Noise Source Agilent N4001A
●Frequency Range: 10 MHz - 18 GHz
●Nominal ENR 15dB
●Electronic storage of Excess Noise Ratio (ENR) calibration data decreases the opportunity for user error -
Used Noise Source Agilent N4000A
DUT's with noise figure up to 20 dB can be accurately and reliably measured with this device. The N4000A noise sources has a choice of connectors, with an APC 3.5(mm) connector as standard.
-
Used Microwave Downconverter Agilent E5053A
When configured with the Agilent E5053A microwave downconverter, the E5052A and E5052B SSA offers exceptional phase noise sensitivity up to 26.5 GHz.
-
Used Signal Source Analyzer Agilent E5052B
The E5052B SSA is suitable for use in a wide range of applications including RF/uW/mmW oscillators, VCO's, system reference clocks, LAN modules, high-speed timing modules, SerDes chips, and...
-
Used Signal Source Analyzer Agilent E5052A
The Keysight E5052A has a frequency range that can be extended up to 26.5 GHz with the Agilent E5053A, and up to 110 GHz with the E5053A plus Keysight 11970 (Agilent) series mixers.
-
Used Noise Source Agilent 346B
The low SWR of the Keysight 346B noise source reduces a major source of measurement uncertainty; reflections of test signals. The 346B's high ENR, low SWR, and variety of connectors make it a...
-
Used Noise Source Agilent 346A
The very small change in reflection coefficient (<0.01) from ON to OFF is designed especially for accurate characterization of input-impedance-sensitive devices (like GaAsFETs and many UHF...


