Phase Noise Analyzers

• Used Phase Noise Analyzer Rohde & Schwarz FSWP8

  The FSWP8 Phase Noise Analyzer does not require external reference sources. Its internal local oscillator surpasses almost any generator available on the market when it comes to phase noise...

• Used Phase Noise Analyzer Rohde & Schwarz FSWP50

  For high-end applications, the Rohde & Schwarz FSWP50 can be equipped with a second receive path, which enables cross-correlation and, depending on the number of correlations used, increases...

• Used Phase Noise Analyzer Rohde & Schwarz FSWP26

  For high-end applications, the Rohde & Schwarz FSWP26 can be equipped with a second receive path, which enables cross-correlation and, depending on the number of correlations used, increases...

• Used Signal Source Analyzer Rohde & Schwarz FSUP50

  The Rohde and Schwarz FSUP26 analyzer is perfect for not only modern communications and broadcast systems, but also radar applications.

• Used Signal Source Analyzer Rohde & Schwarz FSUP26

  Use the FSUP26 to measure phase noise and when characterizing oscillators, measure tuning slope, transient response, power, harmonics and spurious emissions, as well as amplifier noise.

• Used Noise Figure Meter Agilent N8974A

  The Agilent N8974A offers simultaneous noise figure and gain measurements with the ability to view, print and save the data/display in multiple formats.

• Used Noise Figure Analyzer Agilent N8973B

  Default noise figure settings offer simultaneous noise figure and gain measurements. By using Table view several measurements including Noise Figure, Noise Factor, Y-Factor, Gain, Phot, Pcold, and...

• Used Noise Figure Analyzer Agilent N8973A

  The Keysight N8973A offers simultaneous noise figure and gain measurements with the ability to view, print and save the data / display in multiple formats.

• Used Noise Source Agilent N4002A

  The Keysight N4002A (Agilent) Noise Source is perfect for general purpose use with a low reflection coefficent and a nominal ENR of 15 dB from 10 MHz to 26.5 GHz. DUT's with noise figures up to 30...

• Used Noise Source Agilent N4001A

  ●Frequency Range: 10 MHz - 18 GHz
  ●Nominal ENR 15dB
  ●Electronic storage of Excess Noise Ratio (ENR) calibration data decreases the opportunity for user error

• Used Noise Source Agilent N4000A

  DUT's with noise figure up to 20 dB can be accurately and reliably measured with this device. The N4000A noise sources has a choice of connectors, with an APC 3.5(mm) connector as standard.

• Used Phase Noise Analyzer Agilent E5503B

  By building upon 30 years of Agilent Technologies low phase noise, RF design and measurement experience, the Agilent E5503B solution continues to provide excellent measurement integrity,...