China Used Noise Source Agilent 346B Manufacturers Factory Suppliers
-
Used Noise Source Agilent 346B
The low SWR of the Keysight 346B noise source reduces a major source of measurement uncertainty; reflections of test signals. The 346B's high ENR, low SWR, and variety of connectors make it a...
-
Used Phase Noise Analyzer Rohde & Schwarz FSWP50
For high-end applications, the Rohde & Schwarz FSWP50 can be equipped with a second receive path, which enables cross-correlation and, depending on the number of correlations used, increases...
-
Used Phase Noise Analyzer Rohde & Schwarz FSWP26
For high-end applications, the Rohde & Schwarz FSWP26 can be equipped with a second receive path, which enables cross-correlation and, depending on the number of correlations used, increases...
-
Used Noise Figure Meter Agilent N8974A
The Agilent N8974A offers simultaneous noise figure and gain measurements with the ability to view, print and save the data/display in multiple formats.
-
Used Noise Figure Analyzer Agilent N8973B
Default noise figure settings offer simultaneous noise figure and gain measurements. By using Table view several measurements including Noise Figure, Noise Factor, Y-Factor, Gain, Phot, Pcold, and...
-
Used Noise Source Agilent N4002A
The Keysight N4002A (Agilent) Noise Source is perfect for general purpose use with a low reflection coefficent and a nominal ENR of 15 dB from 10 MHz to 26.5 GHz. DUT's with noise figures up to 30...
-
Used Noise Source Agilent N4001A
●Frequency Range: 10 MHz - 18 GHz
●Nominal ENR 15dB
●Electronic storage of Excess Noise Ratio (ENR) calibration data decreases the opportunity for user error -
Used Noise Source Agilent N4000A
DUT's with noise figure up to 20 dB can be accurately and reliably measured with this device. The N4000A noise sources has a choice of connectors, with an APC 3.5(mm) connector as standard.
-
Used Phase Noise Analyzer Agilent E5503B
By building upon 30 years of Agilent Technologies low phase noise, RF design and measurement experience, the Agilent E5503B solution continues to provide excellent measurement integrity,...
-
Used Microwave Downconverter Agilent E5053A
When configured with the Agilent E5053A microwave downconverter, the E5052A and E5052B SSA offers exceptional phase noise sensitivity up to 26.5 GHz.
-
Used Noise Figure Test Agilent 8971C
When paired with the measurement modes in an 8970B, double down-conversion is possible because the 8971C acts as the second downconverter.
-
Used Noise Figure Meter Agilent 8970B
RF and microwave (with external local oscillator, sold separately) measurements from 10MHz to at least 26.5GHz are equally simple; any IF between 10 and 1500 MHz may be used.


